東華大學圖書館 |

語系: 繁體中文

說明(常見問題)

回圖書館首頁

手機版館藏查詢

登入

回首頁

切換: 標籤 | MARC模式 | ISBD

Integrated Wideband Self-Interferenc...

Zhang, Tong.

FindBook

Google Book

Amazon

博客來

Integrated Wideband Self-Interference Cancellation Techniques for FDD and Full-Duplex Wireless Communication.

紀錄類型:	書目-電子資源 : Monograph/item
正題名/作者:	Integrated Wideband Self-Interference Cancellation Techniques for FDD and Full-Duplex Wireless Communication./
作者:	Zhang, Tong.
出版者:	Ann Arbor : ProQuest Dissertations & Theses, : 2017,
面頁冊數:	175 p.
附註:	Source: Dissertation Abstracts International, Volume: 79-01(E), Section: B.
Contained By:	Dissertation Abstracts International79-01B(E).
標題:	Electrical engineering. -
電子資源:	http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=10599061
ISBN:	9780355124828

Integrated Wideband Self-Interference Cancellation Techniques for FDD and Full-Duplex Wireless Communication.
Zhang, Tong.

Integrated Wideband Self-Interference Cancellation Techniques for FDD and Full-Duplex Wireless Communication. - Ann Arbor : ProQuest Dissertations & Theses, 2017 - 175 p.

Source: Dissertation Abstracts International, Volume: 79-01(E), Section: B.

Thesis (Ph.D.)--University of Washington, 2017.

The continued demand for higher levels of wireless access and increased data rates for a variety of applications from mobile smart phones to back haul point-to-point communication, continues to drive research that enables new spectrum opportunities, reduces form factor and lowers the cost of hardware solutions. The current RF spectrum, which is often referred to as the frequency band from 1-6GHz, has become increasingly crowded with only a limited amount of unused and unlicensed spectrum. This dissertation explores and implements, single-chip hardware front-end solutions which the specific aim to increase data rates for each single-user using two techniques: a. Using In-band full-duplex radio techniques with self-interference cancellation; b. High-speed communication using large bandwidths available at mmWave frequencies. The advantages, challenges and achievements associated with the two proposed techniques will be described in the following paragraphs.

ISBN: 9780355124828Subjects--Topical Terms:

649834
Electrical engineering.

Integrated Wideband Self-Interference Cancellation Techniques for FDD and Full-Duplex Wireless Communication.
LDR:06450nmm a2200325 4500 001 2199894
005 20181112153839.5
008 201008s2017 ||||||||||||||||| ||eng d
020 $a 9780355124828
035 $a (MiAaPQ)AAI10599061
035 $a (MiAaPQ)washington:17557
035 $a AAI10599061
040 $a MiAaPQ $c MiAaPQ
100 1 $a Zhang, Tong. $3 1073854
245 1 0 $a Integrated Wideband Self-Interference Cancellation Techniques for FDD and Full-Duplex Wireless Communication.
260 1 $a Ann Arbor : $b ProQuest Dissertations & Theses, $c 2017
300 $a 175 p.
500 $a Source: Dissertation Abstracts International, Volume: 79-01(E), Section: B.
500 $a Adviser: Jacques C. Rudell.
502 $a Thesis (Ph.D.)--University of Washington, 2017.
520 $a The continued demand for higher levels of wireless access and increased data rates for a variety of applications from mobile smart phones to back haul point-to-point communication, continues to drive research that enables new spectrum opportunities, reduces form factor and lowers the cost of hardware solutions. The current RF spectrum, which is often referred to as the frequency band from 1-6GHz, has become increasingly crowded with only a limited amount of unused and unlicensed spectrum. This dissertation explores and implements, single-chip hardware front-end solutions which the specific aim to increase data rates for each single-user using two techniques: a. Using In-band full-duplex radio techniques with self-interference cancellation; b. High-speed communication using large bandwidths available at mmWave frequencies. The advantages, challenges and achievements associated with the two proposed techniques will be described in the following paragraphs.
520 $a First, in-band full-duplex communication potentially increases spectral efficiency within existing RF standards. This will allow the combination of dedicated transmitting and receiving bands into a single band which would more than double the spectral efficiency. However, this leads to an extremely challenging problem associated with transmitter self-interference cancellation. To date, two full-duplex chips have been designed, fabricated and tested, each with a self-interference cancellation function. The first IC is an analog full-duplex front-end for Bluetooth (BLE) applications. Inside the proposed chip, a self-interference cancellation (SIC) circuitry, a low-power receiver, combined with a harmonic-rejection power amplifier (HRPA) are implemented to reduce the transmitter-to-receiver self-interference, and enable full-duplex operation. These techniques were applied towards the realization of a prototype silicon device which implements a tunable self-interference mitigation canceller function with a current-mode LNA and passive-mixer based front-end, and a power amplifier topology to reduce out-of-band emissions. This chip was fabricated in 40nm 6-metal stack CMOS process to achieve more than 30dB measured self-interference cancellation over 4MHz bandwidth, and an integrated power amplifier (PA) which suppresses the 3rd and 5th harmonics by 30dB and 15dB, respectively. The PA delivers a maximum output power of +14dBm with a drain efficiency of 33%. The self-interference cancellation circuitry utilizes an active area of 131x112.5 microm2, has a power consumption of 0.25mW, and degrades the receiver noise figure (NF) by less than 0.6dB. The second IC is a transceiver front-end, which includes a dual-injection path self-interference (SI) cancellation circuitry to enable wideband full-duplex communication with a high-power transmitter. The proposed SI cancellation circuitry is implemented using: (1) one feedforward cancellation path containing a 5-tap analog adaptive filter (AF) between the transmitter (TX) output and the receiver (RX) input; (2) a second cancellation path containing a 14-tap low-frequency AF with a point of injection at the RX baseband output; (3) a phase noise cancellation method which reduces the phase noise (PN) associated with the down-conversion in the BB cancellation path for the TX SI signal; (4) an integrated noise canceling power amplifier (PA). A prototype 40nm TSMC device was fabricated which demonstrates more than 50dB SI cancellation over 42MHz bandwidth and a 10dB attenuation of TX SI PN in the RX signal path. The two cancelling filters dissipates 11.5mW, with a measured P--1dB and IIP3 of 27/26.5dBm and 36/34.5dBm, respectively. The RX noise figure is degraded by less than 1.55dB when both cancelers are enabled. The PA has a measured output of P--1dB/Psat of 25.1/26.5dBm, respectively. The total chip die area is 3.5 mm2 with an overall transceiver power consumption of 49mW excluding the integrated power amplifier.
520 $a Second, although the lower frequency RF band appears saturated, the vast available spectrum at mmWave frequencies (30--300 GHz) presents a potentially attractive solution for high-speed communication. However, communication at mmWave frequencies brings up many new challenging problems for designers when attempting to realize a wideband high accuracy wideband quadrature generator is one of them. One mmWave IC, which includes an integrated two-stage polyphase filter (PPF) with feedback control, is proposed for quadrature local oscillator (LO) generation at millimeter-wave frequencies. To minimize the in-phase (I) and quadrature (Q) mismatch, the second stage of the PPF utilizes triode-region NMOS transistors to implement variable resistors where the resistance is precisely controlled by modulating the shared gate-to-source bias voltage at the gate of NMOS devices. The gate bias voltage of the triode region devices is set by a feedback loop and changes according with variations in process, voltage, and temperature (PVT). A prototype quadrature signal generator, employing this PPF design, is integrated in 28nm LP CMOS process. A worst-case measured phase/amplitude imbalance of 2°/ 0.32dB (TT dies) and 2.2°/ 0.55dB (SS dies) is reported over 7GHz bandwidth for a fixed control current (ICtrl). By retuning ICtrl every 7GHz, this IQ generator would maintain the measured quadrature accuracy from 55-to-70 GHz. (Abstract shortened by ProQuest.).
590 $a School code: 0250.
650 4 $a Electrical engineering. $3 649834
650 4 $a Engineering. $3 586835
690 $a 0544
690 $a 0537
710 2 $a University of Washington. $b Electrical Engineering. $3 2102369
773 0 $t Dissertation Abstracts International $g 79-01B(E).
790 $a 0250
791 $a Ph.D.
792 $a 2017
793 $a English
856 4 0 $u http://pqdd.sinica.edu.tw/twdaoapp/servlet/advanced?query=10599061